General cleaning of components is important to keep your system working well. All components that have no wiring or cables are completely waterproof. Components can be washed with warm water, dish soap and a medium bristle brush.

Before using the scanner, ensure all connectors are free of water and moisture.

NOTE: All components with wiring, cables or electrical connections are splash proof. However, these components are NOT submersible.

NOTE: Never use strong solvents or abrasive materials to clean your scanner components.

See the instructions below for cleaning specific scanner types.

After washing your ROTIX system, use a light oil to lubricate the slide and the adjustment screw on the buckle component.

Before every use, the NAVIC 2 system must be maintained and inspected.

Inspection of safety apparatus: (this includes)

  • All components of tether system. Replace damaged components as necessary.
  • Lifting sling on crawler. If the lifting sling shows signs of damage (e.g. cuts, abrasion, etc) do NOT use.

Clean the drive wheels:

  • Debris will collect on the magnetic wheels. Remove this debris before every use. An effective cleaning method uses adhesive-backed tape (e.g. duct tape) to ‘pull’ the debris off the wheels.

Inspect cables and connectors

  • Inspect the umbilical cable, the controller cable and the power cable for damage. Have any damaged cable repaired by a qualified person or replace the cable assembly as necessary.
  • Inspect all connectors for damage or moisture. Straighten bent pins. Dry connectors before using.

General cleaning

  • Ensure that the scanner stays relatively clean by wiping off any excess dirt or other contaminants after every use.

Before every use, the SKOOT system must be maintained and inspected.

Inspection of safety apparatus: (this includes)

  • All components of tether system. Replace damaged components as necessary.
  • Lifting sling on crawler. If the lifting sling shows signs of damage (e.g. cuts, abrasion, etc) do NOT use.

Clean the drive wheels:

  • Debris will collect on the magnetic wheels. Remove this debris before every use. An effective cleaning method uses adhesive-backed tape (e.g. duct tape) to ‘pull’ the debris off the wheels.

Inspect cables and connectors

  • Inspect the umbilical cable, the controller cable and the power cable for damage. Have any damaged cable repaired by a qualified person or replace the cable assembly as necessary.
  • Inspect all connectors for damage or moisture. Straighten bent pins. Dry connectors before using.

General cleaning

  • Ensure that the scanner stays relatively clean by wiping off any excess dirt or other contaminants after every use.
Did this answer your question?